Your robot is automatically set to periodically send out a Wi-Fi signal that can be picked up as a local network (also called ‘Wi-Fi’ mode). If desired this mode can be switched ‘OFF’, ‘ON’ again or ‘reset’ by following the instructions below:

1. Download the ‘disable’, ‘enable’ or ‘reset’ Wi-Fi software from the Dyson website on to a USB stick without renaming it. The USB stick must have at least 256MB of free space and must have no other files or folders on it

2. The USB stick must be unencrypted and formatted to FAT32 or MS-DOS (FAT)

3. Please Note: For some web browsers, the file may be displayed in the browser instead of prompting you to download it. If this happens, select ‘File’ then ‘Save As’ (or equivalent steps for your specific browser) to save the file on to your USB

4. Remove the post-filter from the robot and insert the USB stick into the USB port on the back of the machine

5. Place the robot on a powererd dock and ensure it is charging. Press and hold the power button until a ring of pink lights flash to indicate that the robot has started the upgrade. Do not attempt to interrupt the upgrade sequence until it has completed. Removal of the battery during an upgrade may cause irreparable damage.
 

6. The software will automatically switch ‘OFF’, ‘ON’ or ‘reset’ Wi-Fi mode (appropriate to the file downloaded)
 

7. Once complete the robot will turn off
 

8. Remove the USB and replace the filter and filter cover. The robot is now ready to use as normal